Audited Supplier
PVC GLAZED TILE ROOF SHEET PRODUCT MACHINE WITH LESS LABOR
Raw material & Final product:
Raw material & formulation | Bottom layer: PVC powder, CaCO3, CPE, PE-WAX, Stearic acid , Compound stabilizer ,ACR, paraffin. |
Description final product & Output | Two layers PVC+ASA Co-extrusion Glazed tile; |
Final product | Main tile:1set |
Machine list:
No. | Machine | Qty. |
|
1 | Screw loader for extruder | 1set | Glazed tile extrusion line |
2 | Conical twin-screw extruder(PVC) | 1set | |
3 | Vacuum loader and drying hopper | 1set | |
4 | Single screw extruder(ASA) | 1set | |
5 | Extrusion mould and distributor | 1set | |
6 | Embossing roller | 1set | |
7 | Temperature controller | 1set | |
8 | Glazed-tile forming machine | 1set | |
9 | Cutter | 1set | |
10 | Stacker | 1set | |
11 | Ridge tile Oven | 1set | |
12 | Ridge tile Forming machine and ridge tile mould | 4set | |
|
|
|
|
13 | Screw loader for Mixer | 1set | Auxiliary equipment |
14 | Mixer unit | 1set | |
15 | Crusher | 1set | |
16 | Pulverizer | 1set |
1,Q:How to solve the problem about material leakage of high mixer quickly?
A:Replace the seal gasket or check the cylinder distance whether it is enough .
2,Q:why the low-mixer is always burned?
A:The mixture exceeds the rated capacity, causing the motor to overload.
3,Q:How to adjust the space of the screw?
A:Log in Polytech official website,, authorized to download the video tutorial.
4,Q:How to solve the the ASA coating problem?
A:Many reasons ,such as temperature, formulation, start-up speed etc.
5,Q:Why the material Burnt?
A:Many reasons, such as high heating temperature, heating preservation time is too long.
6, Q:Why the ASA is covering on the bottom?
A:Many reasons ,such as temperature, formulation, start-up speed does not match.
7, Q:Asymmetrical ASA2/4 area covering?
A:Many reasons ,such as temperature, formulation, start-up speed does not match.
8,Q:How to adjust the dislocation of glazed tile module?
A:By adjusting tooth on the dynamic column to achieve the right location of module.
9, Q:Why Shaping mould two side speed is not synchronization?
A:Two side shaping module is not synchronized.
10,Q:Why the Cutter machine does not move?
A:Replace the sliding bearing seat under rack or moving cylinder.
